The Annovi Reverberi RMW2G24D-PKG – pump package Features:
RMW2G24D – Pump
Max PSI: 2400
Max GPM: 2
RPM: 3400
7/8″ Hollow Shaft
Vertical Gas Engine Flange
TPP140-1/4A – Thermal relief valve
AR1269120 – Detergent tube with filter
List Price: $243.26 Our Price: $156.74 You save $86.52! Availability:: available for order Product Code: RMW2G24-PKG
Annovi Reverberi RMW2G24D-PKG – pump package
PRICE SUBJECT TO CHANGE. PRICE VALID 10/19/2011
This RMW2.2G24-SX-PKG plunger pump will pump up to 2.2 GPM up to 2600 PSI. It spins at 3400 RPM in a direct drive system coupled with a gasoline engine. The matching flange provides convenient connection to most 7/8″ shaft 1.1 – 5.5 HP engines. The hollow shafted pump includes a built-in pressure control valve, thermal relief valve and chemical injection system. App. 6 1/2″ Tall.
RMW2.2G24-SX-PKG annovi reverberi pressure washer pumps are a combination of exceptional degree of technology and innovation, quality and reliability worthy of a leading brand on the market. The wide range includes many models which vary in terms of pressure, deliver, power and technical characteristics, to satisfy widely different market demands
Annovi Reverberi’s Axial series pumps come with a special formulated Synthetic pump oil that contains anti-wear, rust inhibitor and deoxidizer additives designed to last 500 hours.
Annovi Reverberi RMW22G24SX-PKG
The Annovi Reverberi RMW22G24SX-PKG Features:
RMW22G24-EZ-SX – Pump
Max PSI: 2400
Max GPM: 2.2
RPM: 3400
7/8″ Hollow Shaft
Vertical Gas Engine Flange – Rotated 180° from Standard
TPP140-1/4A – Thermal relief valve
AR1269120 – Detergent tube with filter
List Price: $253.86 Our Price: $163.27 You save $90.59!
Availability:: available for order Product Code: RMW22G24SX-PKG
Annovi Reverberi Pressure Washer Pump
PRICE SUBJECT TO CHANGE. PRICE VALID 10/18/2011
The GENERAL PUMP TT SERIES TT2028GBF TRIPLEX PRESSURE WASHER PUMP Features:
Triplex Plunger Pump
Direct Drive Gas Flange
Maximum Volume: 2.85 GPM
Maximum Discharge Pressure: 2000 PSI
Maximum Inlet Pressure: 125 PSI
Maximum Pump Speed: 3400 RPM
Minimum Horsepower Requirements: 5.9 hp for gas engine
Bore: .591″ (15mm)
Stroke: .260″ (6.6mm)
Crankcase Capacity: 11.2 oz. Nondetergent SAE 30W oil
Maximum Fluid Temperature: 165 degrees F.
Inlet Port Thread: 3/8″ FPT
Discharge Port Thread: 1/4″ FPT
Shaft Diameter: 3/4″ Gas Flange
Dimensions: 7.0″ x 7.2″ x 5.5″
Weight: 9 lb.
Lubrication: Fill the crankcase to oil gauge window per specifications with Nondetergent SAE 30W oil. Change the oil after a 40 hour break-in period, then every three (3) months or 500 hour intervals thereafter
GENERAL PUMP TT SERIES TT2028GBF TRIPLEX PRESSURE WASHER PUMP HAS
3/4” HOLLOW SHAFT GAS ENGINE FLANGE
2.8 GPM 2000 PSI 3400 RPM
THE TT2028GBF COMES STANDARD WITH FORGED BRASS MANIFOLD WITH EXCLUSIVE LIFETIME WARRANTY
INLET 3/8″ FPT OUTLET 1/4” FPT
THE GENERAL PUMP TT SERIES TT2028GBF TRIPLEX PRESSURE WASHER PUMP IS COVERED BY GENERAL PUMP FIVE YEAR WARRANTY, PLUS LIFETIME ON THE MANIFOLD
GENERAL PUMP TT SERIES TT2028GBF TRIPLEX PRESSURE WASHER PUMP
GENERAL PUMP TT SERIES TT2028GBF TRIPLEX PRESSURE WASHER PUMP
The following statement is intended to assist our customers in understanding the terms of General Pump’s warranty, the circumstances under which they will honor claims, and the procedure for making such claims.
General Pump/US warrants each pump to be free of defects in material or workmanship for a period of five (5) years from the date of shipment. In addition, General Pump/US warrants all forged brass pump manifolds to be free of defects in material and workmanship and from damage resulting from freezing for the life of the pump. Liability on this warranty is on all non-wear parts and limited to the repair or replacement of any pump returned to General Pump/US which upon inpsection is judged to be defective due to workmanship or material failure.
In the course of marketing or servicing the customer or potential customer’s needs, General Pump/US will use its best judgment in its recommendations. However, the ultimate responsibility for product application decisions shall rest with the customer. the sole and only warranty made by General Pump/US is the limited warranty described above. General Pump/US makes no other warranty or warranties of any kind, express or implied, including any implied warranty or merchantability or of any fitness for a particular use or purpose.General Pump/US disclaims and denies any liability for any direct, indirect, special, incidental or consequential damages which may be suffered as a result of sale, delivery, servicing, use, loss of any product, downtime, labor, freight or other charges not expressly included herein. the only liability and the total liability of General Pump/US under this limited warranty or in any claim regarding or involving General Pump/US is expressly limited to the replacement of or purchase price of the product.
The following items are NOT warranted, due to matters beyond General Pump/US control.
Normal wear and tear to parts that are considered standard wear parts.
Defects caused by the fault or negligence of the buyer or third party.
Use of unauthorized repair parts, or; modifications made by the customer.
List Price: $439.48 Our Price: $338.18 You save $101.30! Availability:: available for order Product Code: BAPL-3583
GENERAL Pressure Washer Pump
PRICE SUBJECT TO CHANGE. PRICE VALID 10/17/2011
List Price: $1,590.00 Our Price: $791.04 You save $798.96! Availability:: available for order Product Code: 6400.1113.00
Comet Pressure Washer Pump
PRICE SUBJECT TO CHANGE. PRICE VALID 10/17/2011
Direct-Drive Misting Motor-Pump-Units CAT Pump 1CX05ELS.MIST ( 1CX05ELSPD501 ) and 8182 Motor (1/2HP, 1PH) Pulse Hose
OPERATION:
A pressure regulator is included with each 1CX plunger pump. The regulator is not pre-set at the factory. Set system pressure once the system is started. Start at the lowest pressure reading and adjust the hex adjusting cap in small increments until the desired system pressure is attained. Remember to service the regulator on the same schedule as the pump seals and valves. Refer to 1CX service manual for start-up, servicing of seals and valves, torque requirements and diagnosis/maintenance chart.
INLET:
It is recommended to install a flexible hose at the pump inlet. Assure flooded or up to 60 psi inlet pressure for optimium
performance. Install an inlet filter to remove standard water debris.
DISCHARGE:
All discharge plumbing for the 1CX pump connects to the
regulator outlet port.
PULSE HOSE MOUNTING:
Mount the pulse hose by installing a tee fitting into the regulator outlet port. Install the pulse hose into the top port. Coil hose and tie wrap as shown. Add nipple with a tee to mount pressure gauge. The other end of the pulse hose is plugged to capture the pulse.
Note: Without a pulse hose, the pump may draw as much as 2 additional AMPS above full load AMPS.
BY-PASS: The regulator by-pass is at the bottom. Connect a 1/4” flexible hose and route to inlet of pump, to tank, or to drain.
NOTICE: By-pass to the pump inlet is designed for cold water or ambient temperature operation.
DO NOT EXCEED 6 MINUTES IN BY-PASS operation. Excessive temperatures will cause premature wear or damage to the pump and VOID THE WARRANTY.
The P1115EC BE pressure washer is an electric power washer that features a reliable 1.5 HP BALDOR Electric Motor Engine, to go along with a high quality Comet Triplex Washer pump. The P1115EC BE pressure washer is the ideal pressure washer for property and small business owners, construction workers and handymen where electricity is available.
Powered by an industrial 1.5HP Baldor electric motor.
Cords, Plugs & Switch Included
This BE P1115EC Electric Pressure Washer has the following technical specifications:
Engine 1.5HP Electric Engine
PSI 1100
GPM 2.0
Comet Triplex Pump
List Price: $1,058.00 Our Price: $755.00 You save $303.00! Availability:: available for order Product Code: P1115EC
BE Pressure Washer
PRICE SUBJECT TO CHANGE. PRICE VALID 10/13/2011
The AR Annovi Reverberi RMW2.2G24D-EZ-SX features a 7/8″ hollow shaft, operates at 3400 RPM, and has a max PSI of 2400. This Annovi Reverberi RMW2.2G24D-EZ-SX pump comes equipped with an Easy Start Valve that eases internal pump pressures that can make cold starts with gasoline engines difficult. The ports on this Annovi Reverberi RMW2.2G24D-EZ-SX pump are also rotated 180 degrees from standard. Manifold is made from precision die cast aluminum.
The Annovi Reverberi Pressure Washer Pump RMW2.2G24-EZ-SX Features:
Max Flow (in GPM): 2.2
Max Flow (in L/Min): 8.3
Max Pressure (in PSI): 2400
Max Bar: 166
Power EBHP: 3.6
Bore Dia: 12mm
Stroke: 8.3mm
Crankshaft ID Stamp: 5
Pump Speed (in RPM): 3400
Shaft Diameter: 7/8″ hollow
Important Notes about the Annovi Reverberi Pressure Washer Pump RMW2.2G24-EZ-SX:
THE AR Annovi Reverberi RMW2.2G24D-EZ-SX PUMP IS COMMONLY FOUND ON RESIDENTIAL USE PRESSURE WASHERS. THESE MACHINES ARE MADE BY SEVERAL MANUFACTURES UNDER NUMEROUS BRAND NAMES. A PARTIAL LIST OF THE BRAND NAMES IS BELOW. THIS PUMP WILL FIT MANY OF THOSE UNITS. THIS PUMP IS MOST OFTEN USED ON MACHINES WHERE THE WATER CONNECTIONS ARE AT THE REAR OF THE MACHINE. CALL OR EMAIL US IF YOU ARE NOT SURE THIS IS THE PUMP YOU NEED.
THIS AR Annovi Reverberi RMW2.2G24D-EZ-SX PLUNGER PUMP WILL PUMP UP TO 2.2 GPM AT 2400 PSI. IT SPINS AT 3400 RPM IN A DIRECT DRIVE SYSTEM COUPLED WITH A GASOLINE ENGINE. THE MATCHING FLANGE PROVIDES CONVENIENT CONNECTION TO MOST 7/8” SHAFT ENGINES. THE HOLLOW SHAFTED PUMP INCLUDES A BUILT-IN PRESSURE CONTROL VALVE, AND CHEMICAL INJECTION SYSTEM.
Use only AR64545 oil for the AR RM, XJ, SJ and BK Series pumps only: Do NOT change oil. Use oil only to add if low. This oil is a specially formulated synthetic with special additives for the demands of the RM, XJ, SJ and BK pump series. No other oil is factory approved for these pumps, and could result in pump failure.
PARTS BREAKDOWN FOR THE RMW2.2G24D-EZ-SX CLICK HERE. List Price: $244.01 Our Price: $157.21 You save $86.80! Availability:: available for order Product Code: RMW2.2G24-EZ-SX
Annovi Reverberi Pressure Washer Pump
PRICE SUBJECT TO CHANGE. PRICE VALID 10/12/2011
List Price: $1,202.04 Call 1-877-824-7763 or email for a better price Availability:: available for order Product Code: 340W
CAT Pressure Washer Pump
PRICE SUBJECT TO CHANGE. PRICE VALID 10/12/2011
COMET PUMP FW 5030 S PART NO. 6400.0202.00, 5.0 GPM @ 3000 PSI @ 1450 RPM, See product spec sheet for detailed specifications, repair kits and replacement parts. Click here.
COMET Pressure Washer Pump FW 5030 S - 6400.0202.00
The COMET Pressure Washer Pump FW 5030 S – 6400.0202.00 Features:
1/2 FPT Inlet, 3/8 FPT Discharge
Anodized, Die-Cast Aluminum Crankcase
Solid Ceramic Plungers
Stainless Steel Check Valves & Piston Guides
Oversized Bronze Connecting Rods
Buna-Textile V-Packings
Reversible Crankcase for Right or Left Hand Mounting
24mm Solid, Keyed Shaft
The COMET Pressure Washer Pump FW 5030 S – 6400.0202.00 has the following specifications:
Maximum Volume 5.0 gpm
Max. Discharge Pressure 3000 psi
Maximum Pump Speed 1450 rpm
Inlet Port Thread 1/2 FPT
Discharge Port Thread 3/8 FPT
Shaft Diameter 24mm Solid
Piston 20mm
Weight 19.4 lbs.
List Price: $1,085.00 Our Price: $542.34 You save $542.66! Availability:: available for order Product Code: 6400.0202.00
Comet Pressure Washer Pump
PRICE SUBJECT TO CHANGE. PRICE VALID 10/6/2011